Monarch 9800 User Manual download pdf (Page 31)

Adjusting Print Positions

You can adjust the supply, print, margin, or cut positions on the

9840 printer by using the control panel buttons. Make sure a

batch is not waiting to print before you adjust the positions.

To change the supply, print, margin, or cut positions:

1. Press Pause.

2. Press Feed and Clear (at the same time) once to select the

supply position, twice to select the print position, three times

to select the margin position, and four times to select the cut

position. These buttons act as toggle switches between the

four (supply, print, margin, and cut) position adjustments.

When you select the position to change, the

current setting is displayed.

3. Press Feed to decrease the current position by one dot or

press Feed for two seconds to decrease the value by 10 dots.

Press Clear to increase the current position by one dot or

press Clear for two seconds to increase the value by 10 dots.

If the position has a negative value, the

supplies light is on.

After you adjust the position (and release the

buttons), the setting is displayed.

4. Press Pause when you are done making adjustments.

Resend the format so these changes take effect. You

cannot change the settings if the printer is paused while

printing a batch. Change the settings after the batch is

done printing.

Review the following definitions for the different print position

adjustments.

Printing 4-3

Rev. A 10/98

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

No comments

Monarch 9800 User Manual Page 31